Id O Matic. CruiseOMatic Identification Ford Muscle Forums Ford Muscle Cars The 10-pin terminal block used on the ID-O-Matic III is replaced with a 12 pin block Several modes of operation make it suitable for use in the shack or as an automatic Morse code ID for beacons, repeaters and "fox hunt"
IDOMATIC IV 4 RadioDan from radiodan.com
The ID-O-Matic II kit is available at www.Hamgadgets.com An optional "Courtesy (Roger) Beep" when the incoming carrier is dropped
IDOMATIC IV 4 RadioDan
The ID-O-Matic II kit is available at www.Hamgadgets.com The ID-O-Matic II kit is available at www.Hamgadgets.com The DB9 connector and serial port used on the ID-O-Matic II are replaced by a USB mini-B connector
RetractOMatic Extra Pin Allflex ( Identification ID Tags. This unit allows you to connect two ham radios back-to-back creating a standalone VHF/UHF repeater Current Assembly & Instruction manual, firmware V3.5 or newer, PCB rev D
ID O Matic Setup Troubleshooting PDF. The "beep" consists of one or more characters sent in audible morse code. Page 2 Unused, leave unconnected Reset input, active LOW.